Bulk Pak Nylon Washers - 1/4", Pack of 100 from FASCO FASTENERS
These washers are white nylon for cushioning.

3/8" Bow/Stern Eye - 1.03" ID Between Studs x 4.63" Thread Length from SUNCOR
Bow / Stern Eye 304 Stainless Steel - Formed . Each U-Bolt set includes four nuts (two standard and two beveled) . Includes one bow plate, and one stern plate. . Threads are "UNC". . Stock size: 3/8" . ID between studs: 1. 03" . Thread length: 2. 50" .

Series 150 Clear PVC Tubing, 1/2"ID, 45psi Burst Pressure from SHIELDS RUBBER
Single layer, nontoxic, FDA-approved clear vinyl tubing. Ideal for drain lines, iceboxes, refrigerators, livewells, bilge pump discharge, freshwater lines, water and holding tank vents. Sold per foot: 50’ maximum continuous length for 1/4" and 3/8" hose; 100' maximum continuous length for 1/2" hose and larger. Application: Non-pressurized water system supply; sink, shower, and icebox drains. Material: FDA formula vinyl. Reinforcement: None. Temperature Range: N/A.

Polycord Value Pack (10 polycords in assorted colors & lengths) from POLYFLEX
Unaffected by chemicals, sunlight, salt water and oil. Perfect for cover tie-downs, lashing jibs on deck when the chute is up, etc. Molded elastomers with glass-reinforced nylon hooks always return to original length.

ADJ 7-15-DL Whisker Pole, 83"/9lb. Collapsed Length/Weight, 202" Max. Working Length, 2" Tubing Diameters from FORESPAR
These telescoping whisker poles are heavy-duty two-section and three-section aluminum spars which can be extended to lengths up to 17' and securely locked in position by an internal twist lock device. Poles feature self-latching Ultra Series™ fittings on the inboard and outboard ends. Aluminum tubing. End Fitting Inboard: UPX. End Fitting Outboard: UPX.

V. 1-7/8"L x 5/8"W Eye Strap, 1/2" Fairlead Width, 1-3/8" Hole Centers, Two #10 RHMS Fasteners from RONSTAN
Eye straps are convenient for lashing points and attaching control line leads or blocks.

5/8" Clevis Pin dia., 1-3/16" inside dia., 4-pack from WEST MARINE
Stainless-Steel Cotter Rings.

Capstan 1000 Rope Winch from POWERWINCH
Versatile system uses an easy to operate foot switch to retrieve anchors or fishing pots or provide power assistance on limited crew sailboats. Solid, 1-piece, machined capstan features aluminum housing with stainless steel internal shafts and hardware. Deck mounted design saves space for rope locker. Mounting template included. Pulling Power: 1000lbs. Speed Up: 40'/min. Boat size: to 55' . Rope Type: 3-strand nylon. Draw: 27A @12v. Measure 6 5/16"H x 8"W x 10 9/16"L.

29mm Carbo Clew Block Assembly from HARKEN
From the folks who invented ball bearing blocks, this line of blocks boasts an excellent strength-to-weight ratio. 29mm doubles and triples feature a U-lock to hold the swivel in the front or side position, or allow it to spin freely. Use the 40mm blocks for jib and mainsheet systems on high-performance dinghies, and for high-load control lines on small keelboats. The 57mm blocks have an enormous working range that makes them ideal for main and jib sheets, spinnaker halyards and control lines.

Large Anchor & Rode Bag from WEST MARINE
Anchor Bag Durable mesh bag provides a convenient and tangle-free place to store your anchor rode. A number of features add to the life of your rode and make it easier to deploy. The wide mouth is held open with an internal stainless steel ring, but closes easily with a drawstring. . Mesh ends dry quickly and a reinforced slit in the bottom allows the bitter end to be passed outside the bag for securing. Brass boat snap allows you to hang the bag and rode where they’re most convenient.

Roller Shaft Cap Nuts Only - 1/2", Pack of 8 from C E SMITH
Roller Size Length Shaft Diameter Shafts and Nuts 4" 5 1/4" 1/2" 4" 5 1/4" 5/8" 5" 6 1/4" 1/2" 5" 6 1/4" 5/8" 8" 9 1/4" 5/8" 10" 11 1/8" 5/8" 11" 12 3/4" 1/2" 12" 13 1/2" 5/8" Shaft Only 18" 19" 5/8" Cap Nuts Only Packs of 8.

Replacement Delrin Roller, 3" Dia., 3-3/8" Width from LEWMAR
Anchor rollers make dropping and weighing anchor easier on you and your boat. They help reduce chafe, prevent scratches and dings to your boat’s finish and provide a secure place to store your anchor when used in conjunction with an optional chain stopper or tensioner. We stock rollers to fit the most common combinations of anchor, mounting style and boat. Installation note: overhanging anchor rollers should be supported along at least 2/3 of their length. Easily installed using common tools.

Lateral Starboard Clamcleat, 1/4"–3/8" Rope Dia., 3/16"H x 2"W x 2-7/8"L, 1/4" Fasteners from CLAMCLEAT
.

Spring Loaded Ring Pull, Square 2 x 2 3/8" from WEST MARINE
Spring-loaded ring immediately returns to flush when released. Type 304 stainless steel . Size: 2 x 2 3/8" .

Replacement Delrin Roller, 2-1/2" Dia., 1-3/4 Width from LEWMAR
Anchor rollers make dropping and weighing anchor easier on you and your boat. They help reduce chafe, prevent scratches and dings to your boat’s finish and provide a secure place to store your anchor when used in conjunction with an optional chain stopper or tensioner. We stock rollers to fit the most common combinations of anchor, mounting style and boat. Installation note: overhanging anchor rollers should be supported along at least 2/3 of their length. Easily installed using common tools.