8 HP 4-Stroke Outboard, 84lb., 15"L from MERCURY MARINE
Clean running 4-stroke engines from 2. 5 to 20hp have a CARB three-star, ultra-low emissions rating. The decompression system and electronic CD ignition design ensure an easy, reliable start. One-stage over-rev protection and low oil pressure warning system provide extra peace of mind. 9hp models features shift, steering, throttle, throttle friction, and stop controls for convenient one-hand operation. Available in manual-tilt, gas-assist and power-trim. All models are sold with a propeller.

Port/Starboard Pair, Chrome-Plated Zinc Case, 5-1/2” x 3-1/8 x 1-3/4” from PERKO
Two sidelights with 1nm visibility intended for vertical cabin sides. Chrome-plated zinc. For sail or power boats less than 12m or 39. 4'. Case Material: Chrome-plated brass . Mounting Hardware: #4 FHMS (Model 281147), #8 FHMS (Model 268518) . Volts: 12V . Draw: 0. 7A . Replacement Bulb: Model 297376 .

Port/Starboard Pair, Chrome-Plated Brass Case, 4-1/4” x 2-3/8” x 1-3/4” from PERKO
Two sidelights with 1nm visibility intended for vertical cabin sides. Chrome-plated zinc. For sail or power boats less than 12m or 39. 4'. Case Material: Chrome-plated brass . Mounting Hardware: #4 FHMS (Model 281147), #8 FHMS (Model 268518) . Volts: 12V . Draw: 0. 7A . Replacement Bulb: Model 297376 .

Rail MT Rod Holder 7/8" from MENGO-DOTLINE
9"L stainless steel holder with pivoting socket adjusts to any angle and lets you simultaneously set the hook and retrieve the rod. Mounts on round, square, hexagon, and octagon rails. Aluminum base plate. No drilling required. Mounting clamp on bottom. Fits 7/8" and 1" OD round rails or 1 1/8" and 1 1/4" square rails. 9"L x 1 7/8" dia. Made in U. S. A. Model URH-190.

Standard 6.3gpm Pump, 3-3/8"H x 4-3/4"W x 6-3/8"L, 4' dry/20' lift when primed from JABSCO
Self-priming pump can be located above the fluid source and can lift it up to 4'Bronze pump head resists corrosion, and bronze body features a reusable O-ring-type end-cover seal. Complies with USCG 183. 410 and ISO 8846 (ignition protection). Application: Bilge pump, livewell circulation, washdown, general pumping requirements . GPM: 6. 3 (fwd), 7. 8 (reverse) . Self-Prime: 4 ft. dry suction (self-priming) lift, 20 ft. lift when primed . Material: Bronze body, neoprene impeller .

T-50 Monel Staples - 3/8' from ARROW FASTENER CO IN
Monel is used extensively for much of the finished hardware in the Marine trade. It is also used extensively in areas that are exposed to salt and other corrosive air. Monel is superior to stainless steel in that stainless steel will oxidize, rust and corrode when exposed to certain corrosive air. Leg length: 3/8" (10mm). Crown width: 3/8" (10mm). Pack Size: 1,000. 100% corrosion resistant staple. Ideal for Marine or outdoor use.

9.9 HP 4-Stroke Outboard, 84lb., 15"L from MERCURY MARINE
Clean running 4-stroke engines from 2. 5 to 20hp have a CARB three-star, ultra-low emissions rating. The decompression system and electronic CD ignition design ensure an easy, reliable start. One-stage over-rev protection and low oil pressure warning system provide extra peace of mind. 9hp models features shift, steering, throttle, throttle friction, and stop controls for convenient one-hand operation. Available in manual-tilt, gas-assist and power-trim. All models are sold with a propeller.

1-5/8" Deck Fitting, 1-1/4" NozAll Dia., 16 Threads/In, Fits All Pre-1995 Fills from SEALAND
The tough plastic adapter screws into your existing deck fitting and makes an airtight seal with pumpout station’s nozzle. Makes emptying your holding tank as clean, easy and fast as a trip to the gas station.

250 Cub/min, 24V DC, 4" In, 3-5/8" Out, 8-3/4"L x 8-3/4"W x 9"H from JABSCO
Designed to remove gasoline vapors from enclosures, these blowers are also a medium-duty, versatile means of exhausting warm air from galleys and engine rooms, ventilating odors or steam from heads and general marine air circulation. Constructed of a tough reinforced plastic housing . One-piece balanced plastic rotor f. Maximum corrosion-resistance in marine environments.

Small, 7 Holes, 1-7/8" Adj. Range, 1/4" Chainplate Pin Dia., 1/8" Wire Dia. from JOHNSON, C.S.
Permit easy rigging adjustments, and allow masts to be stepped and unstepped easily. The lever is easy to open and close under load and has a quick release pin for security. Working Load Small: 400lb.

1-5/8" Deck Fitting, 1-1/2" NozAll Dia., 11.5 Threads/In, Fits All Scandvik from SEALAND
The tough plastic adapter screws into your existing deck fitting and makes an airtight seal with pumpout station’s nozzle. Makes emptying your holding tank as clean, easy and fast as a trip to the gas station.

1-7/8" Deck Fitting, 1-1/2" NozAll Dia., 11.5 Threads/In, Fits Model 243545 from SEALAND
The tough plastic adapter screws into your existing deck fitting and makes an airtight seal with pumpout station’s nozzle. Makes emptying your holding tank as clean, easy and fast as a trip to the gas station.

Poly Rod Rack - 4 Rod from WEST MARINE
High-density polyethylene racks, guaranteed for life. For vertical or overhead mounting. Mounting feet and stainless steel screws are included. Sold in pairs. 2-Rod Rack: 8-1/2"L x 2-7/8"H x 3/4"D. 4-Rod Rack: 15-1/2"L x 2-7/8"H x 3/4"D.

140 Cub/min, 115V AC, 3" In, 2-3/4" Out, 8-3/8"L x 6-5/8"W x 7-5/8"H from JABSCO
Designed to remove gasoline vapors from enclosures, these blowers are also a medium-duty, versatile means of exhausting warm air from galleys and engine rooms, ventilating odors or steam from heads and general marine air circulation. Constructed of a tough reinforced plastic housing . One-piece balanced plastic rotor f. Maximum corrosion-resistance in marine environments.

Quick Fist Clamp - Pair from DAVIS INSTRUMENTS
The Quick Fist® keeps anything from tools to boathooks firmly in place in any vehicle or vessel, while the Super Quick Fist® secures larger equipment like fire extinguishers, Oxygen or CO2 tanks to your boat or truck for easy transport. Heavy duty, UV-resistant rubber withstands extreme heat or cold and will not rust or corrode. Quick Fist Holds Tube Dia. 7/8" to 2-1/4", Safe Working Load 22lb. Super Quick Fist Holds Tube Dia. 2-1/2" to 7 1/2", Safe Working Load 50lb.