Aluminum Transom Support Master Mounting Kit from TELEFLEX
Universal mount for most outboard engine steering applications. This kit includes the Teleflex Outboard Clamp Block, Support Tube, and the Clevis Kit.

Universal Rail Mount with Slot Screw for 1" Rails (Pair) from LIFESLING
Each kit includes all required mounting hardware.

"Little" Crane, 175 lb. Capacity, 30" Arm Reach, 7:1 Purchase, 75' Line Length from ST. CROIX MARINE
Precision engineered and fabricated from stainless steel, these removable cranes lift heavy loads with ease. Best of all, it takes just 20 seconds to set up or remove for storage. Optional spare mounting kits (VPN #176 & 196) include a set of brackets and rail clamps for an extra mounting location. Material: Polished stainless steel. Height: 60" mast height. Mounting Style: Horizontal or vertical mounting to railing. Included Equipment: Complete kit with mounts and 5/16" line.

CARB GASKET KIT from SIERRA
Sierra carb kits and gaskets for engine tune ups.

Yamaha Carb Kit from SIERRA
Sierra carb kits and gaskets for engine tune ups.

Lower Unit Seal Kit from SIERRA
Sierra 18-2623 OMC Gear Housing Seal Kit.

Lower Unit Seal Kit from SIERRA
Lower Unit Seal Kit.

Exhaust Flapper Valve - 4" from SIERRA
Heavy duty rubber flapper valve keeps following seas from entering exhaust outlet when moving slowly or stopping.

Exhaust Bellows - Mercury - Replaces 32734A3, 18654A1 from SIERRA
Seals the exhaust/water flow from the manifold to the exhaust outlet in the drive.

Micro Carbo-Cam Cleat Kit with 423 Cam, 329 Fairlead from HARKEN
Micro Cam-Matic cleats are legendary for smooth, positive operation when holding and releasing control lines. Mounted aft of the cam, fairleads allow you to engage and release a line up to 45° on either side of the cam. Mounted ahead of the cam, fairleads allow moving lines, such as small catamaran traveler controls, to lead properly. Cam kits include: Cam-Matic® cam cleat: Pawls open/close easily on ball bearings . Large diameter low-friction guides with stainless steel tubes protect lines .

Service Kit for Gusher MKIII, Cabinet Mount Foot Pump. from WHALE PUMPS
Parts service and repair kits for Whale Water Systems Units.

Sierra-Tube-Exhaust from SIERRA
Some larger V-8 engines that create a large amount of back pressure use exhaust tubes rather than bellows. This helps to relieve the excessive pressure and eliminate problems with premature bellows failure. In the past, the exhaust bellows would blow up like a balloon and cause the drive shaft bellows to rub against the yoke and U-joints causing holes in the bellows.

Fits all Cobra. Replaces OMC 914036 from SIERRA
Seals the exhaust/water flow from the manifold to the exhaust outlet in the drive.

Replaces OMC P/N 378444 from SIERRA
Many of Sierra's solenoids are manufactured by our Independence, KS plant. We produce both starter solenoids and continuous duty solenoids for trim and tilt pumps. Our features add up to solenoids which offer maximum magnetic plunger pull, reduced voltage drop and maximum corrosion protection.

For Chrysler/Force, 89-817109A2 from SIERRA
Many of Sierra's solenoids are manufactured by our Independence, KS plant. We produce both starter solenoids and continuous duty solenoids for trim and tilt pumps. Our features add up to solenoids which offer maximum magnetic plunger pull, reduced voltage drop and maximum corrosion protection.