Top Sellers
1/4" NPT X 3/8" Brass hose barb from MOELLER
1/4 NPT X 3/8" Brass Hose barbs with male threads.
|
|
|
|
|
Rim Latch Sets - Reverse Bevel with Flush Strike from PERKO
Chrome-plated zinc. Sliding lock button. Case size: 2 1/8'' x 1 3/4''. Escutcheon Size: 4 3/8'' x 1 1/4''. For Door: 5/8'' to 1 3/8''.
|
|
|
Series 150 Clear PVC Tubing, 1/2"ID, 45psi Burst Pressure from SHIELDS RUBBER
Single layer, nontoxic, FDA-approved clear vinyl tubing. Ideal for drain lines, iceboxes, refrigerators, livewells, bilge pump discharge, freshwater lines, water and holding tank vents. Sold per foot: 50’ maximum continuous length for 1/4" and 3/8" hose; 100' maximum continuous length for 1/2" hose and larger. Application: Non-pressurized water system supply; sink, shower, and icebox drains. Material: FDA formula vinyl. Reinforcement: None. Temperature Range: N/A.
|
Brass Reducer, 1/4"NPT x 1/8" FNPT from MOELLER
Barb-Fuel 1/4Fnp x 1/8Mnpt Brs|Barb-Fuel 1/4Fnp x 1/8Mnpt Brs.
|
2-Tank System, 30/35” Gauge from HART SYSTEMS, INC.
Convenient, easy to use, simple to install and far superior to a dip stick, sight glass or an electric float gauge, Tank Tender uses air pressure to provide accurate readings for up to ten tanks. No electrical connection is necessary. With this system, you just select a tank to measure, pump in a small amount of air from the bridge and in two or three seconds you have a reading. We offer systems here for 30" deep tanks. Panels measure 4"W x 8"H x 2-7/8"D.
|
Flush Cup Door Latch from PERKO
Chrome plated zinc alloy with sliding lock button. For door thickness 3/4 to 1-1/8 inches. Supplied with black plastic spacer for surface mounting. Bevel/Strike Type: Regular w/Box. Case Dimensions: 2-1/8 x 1-3/4 .
|
|
|
Rechargeable Signal Air Horn from TAYLOR
Environmentally safe air horn uses air as a propellant, instead of the traditional gas-filled designs. It's economical too. no more expensive refills to buy. Recharges in seconds with a gas station air pump, air compressor, or any other mechanical compressed air source including hand pumps. Works in all weather extremes and can safely be used or stored near sources of heat. Provides approximately 20 blasts per charge. This loud horn puts out a powerful 120db. Meets all USCG regulations.
|
Roller Shaft Cap Nuts Only - 1/2", Pack of 8 from C E SMITH
Roller Size Length Shaft Diameter Shafts and Nuts 4" 5 1/4" 1/2" 4" 5 1/4" 5/8" 5" 6 1/4" 1/2" 5" 6 1/4" 5/8" 8" 9 1/4" 5/8" 10" 11 1/8" 5/8" 11" 12 3/4" 1/2" 12" 13 1/2" 5/8" Shaft Only 18" 19" 5/8" Cap Nuts Only Packs of 8.
|
CARB GASKET KIT from SIERRA
Sierra carb kits and gaskets for engine tune ups.
|
Yamaha Carb Kit from SIERRA
Sierra carb kits and gaskets for engine tune ups.
|
Replaces OMC P/N 378444 from SIERRA
Many of Sierra's solenoids are manufactured by our Independence, KS plant. We produce both starter solenoids and continuous duty solenoids for trim and tilt pumps. Our features add up to solenoids which offer maximum magnetic plunger pull, reduced voltage drop and maximum corrosion protection.
|
|
Packing from SIERRA, 4" from FASCO FASTENERS, 8"D from TAYLOR
|
This site contains about 37,785 documents.
|
|
View by:
Title
|
Category
|
Manufacturer
|
Part No
|
Price
|
|
Page:
1
100
200
300
400
500
600
700
800
940
950
960
970
980
990
1,000
1,010
1,020
1,026
1,027
1,028
1,029
1,030
1,031
1,032
1,033
1,034
1,035
1,036
1,037
1,038
1,039
1,040
1,041
1,042
1,043
1,044
1,045
1,046
1,047
1,048
1,049
1,050
1,051
1,052
1,053
1,054
1,055
1,060
1,070
1,080
1,090
1,100
1,110
1,120
1,130
1,140
1,200
1,260
|
|
|
Home -> Fasteners -> Mechanical Fasteners->Metric Nylock Nuts Bulk Pack
Type 18-8 stainless steel.
Part No: 4722
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Packing-Teflon|**Packing-Teflon.
Part No: 4722
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Packing-Teflon|**Packing-Teflon.
Part No: 4723
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Packing-Teflon|**Packing-Teflon.
Part No: 4724
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Packing-Teflon|**Packing-Teflon.
Part No: 4725
|
|
|
|
Home -> Fishing -> Fishing Accessories
Nylon bull bag, half smooth durable nylon and half heavy open mesh nylon with locking closure. Allows for the lobster to slip in your bag without getting tangled up in mesh at the top of a bag.
Part No: 4727
|
|
|
|
Home -> Fasteners -> Mechanical Fasteners->Tapping Screws - Slotted Oval Head - Bulk
Type 18-8 stainless steel.
Part No: 472A
|
|
|
|
Home -> Sailboat -> Cleats & Stoppers -> Cam and Clam Cleats->Cam-Matic Cleat Kits with Fairleads
Micro Cam-Matic cleats are legendary for smooth, positive operation when holding and releasing control lines. Mounted aft of the cam, fairleads allow you to engage and release a line up to 45° on either side of the cam. Mounted ahead of the cam, fairleads allow moving lines, such as small catamaran traveler controls, to lead properly. Cam kits include: Cam-Matic® cam cleat: Pawls open/close easily on ball bearings . Large diameter low-friction guides with stainless steel tubes protect lines .
Part No: 473
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Packing-Teflon|**Packing-Teflon.
Part No: 4730
|
|
|
|
Home -> Anchor & Docking -> Fenders & Docking -> Dock Steps & Boxes->Polyethylene Dock Steps
Make climbing aboard easier! Durable, UV-resistant, white polyethylene steps have StepSafe non-slip pads for maximum slip protection. Wide 1-1/2" flange makes dock mounting easy. Washable surface cleans easily with soap and water. Handrail and mounting hardware sold separately.
Part No: 47300
|
|
|
|
Home -> Anchor & Docking -> Fenders & Docking -> Dock Steps & Boxes->Dock Step Railing
Aluminum hand rails mount easily to Polyethylene Dock Steps. Fasteners included .
Part No: 47301
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Packing-Teflon|**Packing-Teflon.
Part No: 4731
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Packing-Teflon|**Packing-Teflon.
Part No: 4732
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Packing-Teflon|**Packing-Teflon.
Part No: 4733
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Packing-Teflon|**Packing-Teflon.
Part No: 4734
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Packing-Teflon|**Packing-Teflon.
Part No: 4735
|
|
|
|
Home -> Sailboat -> Cleats & Stoppers->Micro Cam Cleats & Accessories
Delrin® ball bearings allow pawls to open and close effortlessly under both high and low loads; just pull the line straight down, and the cam opens and holds perfectly. Cam-Matics® Cam-Matics feature Hardkote anodized aluminum pawls, three rows of ball bearings (two on the 338), and are designed for high-load, high wear applications. Carbo-Cams® Perfect for racing boats. X-Treme Angle Fairleads Allows releasing and recleating at angles up to 90° to the cleat, unlike any other fairlead.
Part No: 474
|
|
|
|
Home -> Safety -> PLBs, EPIRBs, Life Rafts, Survival
Survival (in a bottle) was the very first model designed by LifeLine and it is their #1 selling model. With smart contents that provide Hydration/Warmth/Light/Safety and an attractive price there is little wonder why it has been such a hit! Packed inside of the 32oz carabiner topped water bottle you will find: Flashlight, AA Size. Emergency Blanket. Whistle, 5 in 1. 3" carabiner attached to loop. Batteries, AA. Poncho.
Part No: 4742
|
|
|
|
Home -> Plumbing -> Fittings & Valves
Provide low-cost insurance against sinking in the event a thru-hull valve or fitting breaks off.
Part No: 47428
|
|
|
|
Home -> Cabin & Galley -> Refrigeration & Coolers
p>The perfect cooler that keeps your refreshments chilled, is light weight and easily transported.
Part No: 47444
|
|
|
|
Home -> Engine Systems -> Engine Parts->Noise Control Barrier Material
The 3/32" flexible vinyl sheet is fused between two layers of foam—an exterior (“decoupler”) layer and an interior (“absorber”) layer. The exterior layer is then covered with a thin film (2. 5 mil) of mylar, reinforced with elastomer-coated fiberglass, for surface heat protection and enhanced sound absorption. The overall effect is a dramatic noise reduction when compared with single-layer foam barriers. Available in two overall thicknesses. Peel and stick backing for easy installation.
Part No: 47468
|
|
|
|
Home -> Fasteners -> Mechanical Fasteners -> Fasteners (100 Pk Bagged)->Bronze Frearson (R & P) Flat Head Wood Screws - Bulk Packs
Silicon Bronze - the generic term used for various types of copper-silicon alloys. The properties of the alloy; a high percentage of copper, and small amounts of silicon, manganese or aluminum added for strength.
Part No: 4747
|
|
|
|
Home -> Sailboat -> Cleats & Stoppers->Micro Cam Cleats & Accessories
Delrin® ball bearings allow pawls to open and close effortlessly under both high and low loads; just pull the line straight down, and the cam opens and holds perfectly. Cam-Matics® Cam-Matics feature Hardkote anodized aluminum pawls, three rows of ball bearings (two on the 338), and are designed for high-load, high wear applications. Carbo-Cams® Perfect for racing boats. X-Treme Angle Fairleads Allows releasing and recleating at angles up to 90° to the cleat, unlike any other fairlead.
Part No: 475
|
|
|
|
Home -> Engine Systems -> Engine Parts->Noise Control Barrier Material
The 3/32" flexible vinyl sheet is fused between two layers of foam—an exterior (“decoupler”) layer and an interior (“absorber”) layer. The exterior layer is then covered with a thin film (2. 5 mil) of mylar, reinforced with elastomer-coated fiberglass, for surface heat protection and enhanced sound absorption. The overall effect is a dramatic noise reduction when compared with single-layer foam barriers. Available in two overall thicknesses. Peel and stick backing for easy installation.
Part No: 47500
|
|
|
|
Home -> Engine Systems -> Engine Parts->Noise Control Barrier Material
The 3/32" flexible vinyl sheet is fused between two layers of foam—an exterior (“decoupler”) layer and an interior (“absorber”) layer. The exterior layer is then covered with a thin film (2. 5 mil) of mylar, reinforced with elastomer-coated fiberglass, for surface heat protection and enhanced sound absorption. The overall effect is a dramatic noise reduction when compared with single-layer foam barriers. Available in two overall thicknesses. Peel and stick backing for easy installation.
Part No: 47501
|
|
|
|
Home -> Fasteners -> Mechanical Fasteners->Fender Washers - Bulk Packs
Type 18-8 stainless steel.
Part No: 4751
|
|
|
|
Home -> Engine Systems -> Engine Parts->Thermostat Housing Gaskets & O-Ring
GASKET; THERMOSTAT COVER.
Part No: 47510Q
|
|
|
|
Home -> Fasteners -> Mechanical Fasteners->Fender Washers - Bulk Packs
Type 18-8 stainless steel.
Part No: 4752
|
|
|
|
Home -> Fasteners -> Mechanical Fasteners->Fender Washers
Type 18-8 stainless steel.
Part No: 4753C
|
|
|
|
Home -> Engine Systems -> Engine Parts->Thermostat Housing Gaskets & O-Ring
GASKET; THERMOSTAT COVER.
Part No: 47590Q01
|
|
|