Stainless-Steel Horizon™ Claw Anchors 11lb. 15'-25' from LEWMAR
Made of precision-cast 316 stainless steel, these claw anchors are patterned after anchors developed to secure oil rigs in the North Sea. Extremely effective in a variety of sea beds, tides, and wind conditions. Reset fast if they become dislodged due to changing conditions. Stows conveniently on the bow roller of most boats.

Cabinet Handle, Stainless Steel Bar 13" from WEST MARINE
Brushed, 304 grade stainless steel pull handles feature smooth rounded ends, hidden fasteners and a stylish contemporary Euro design. Wide range of sizes available from 6 1/4" to 25" for cabinets and drawers of all sizes.

304 Stainless-Steel Hose Clamp, 3-1/8" to 4", SAE Size 56 from NORMA
With 9mm-wide (3/8") non-perforated bands, and made of stainless steel, these clamps feature rolled-up edges to prevent hose damage. We recommend two clamps per hose end below the waterline. Hoses are measured by inside diameter, so select a clamp with a maximum opening at least 1/4" larger. Designed to evenly distribute tension force . Work well in many different applications with a high mechanical load .

Stainless-Steel Rub Strake, 1"W x 24"L from TACO PRODUCTS
Polished stainless steel guards protect lines against chafe from cap rails, gunwales, etc. Material: Marine-grade stainless steel .

Rounded Oval, 8-1/2"W x 11-1/4"L x 5-1/4"D, 1" Flange, 1-1/2" Drain from AMBASSADOR MARINE
Made from 304 stainless steel and mirror-polished to a deep luster, these sinks incorporate SoundKOTE Noise Reduction Technology to reduce the unpleasant clanging associated with many metal sinks. Flanges permit over- or under-the-counter mounting. Low-Profile 90° drains fit standard 1"ID hose and are slanted to maximize drainage.

Deck Fill, Gas, w/Key, 1-1/2" from WHITECAP INDUSTRIES
Stainless-steel deck fills with durable cast heads—not the thin stamped heads found on many imports. Gas, Diesel and Water fills have 1 1/2" openings. Waste fill has 2" opening. All connect to 1 1/2" hose, and include a stainless key. Material: Stainless . Attachment Method: 1 1/2" hose . Flange Diameter: 3" or 3 1/2" (waste) . Fasteners: Three #10 FHMS . Cutout Diameter: 1 5/8" .

Box Anchor, Large, Offshore Boat to 40', Cabin Cruiser to 32', 25lb., 25"H x 9.5"L x 5.5"W Collapsed, Stainless from SLIDE ANCHOR
Recommended for protected waters or beach use, this anchor’s unique shape enables it to set in most bottom types with half the rode normally needed for conventional anchors. Its fixed scoop design and narrow side panels set like a “cookie cutter” into sand, mud, grass or rock. A stabilizing bar and spring make it easy to lock the anchor open for use or collapse it for storage. Stainless-steel version is cast and polished 304 stainless. Style: Box . Material: Galvanized steel/stainless steel.

Adjustable Lock from TAYLOR
Three-part system provides easy snap-on/snap-off fender attachment and adjustment. A stainless base mounts to your boat, into which a peg snaps to hold the fender strap (sold separately). Fixed peg requires tying a knot to secure the fender at the desired height. Adjustable peg - adjust fender height by simply pulling on the strap. Max.

Stainless Portlight from LEWMAR
The Stainless Portlight features a highly polished stainless outer frame with a mirror finish quality. The handles and hinge systems are from the Standard Portlight and leave the lens clear of obstructions for a cleaner look. Smoked gray acrylic lens, stainless steel frame. Latches with quick action handles. Friction hinges hold position without stays or straps. Cutout template included. Comes with trim ring, fasteners, template and instructions.

8' dia. Bird Spider from BIRD B GONE
Stainless steel “arms” of the Bird Spider move with the breeze, deterring birds from landing and causing damage to your boat, rooftop, lights, signs and more. It’s easy to install and maintain and will not harm people or birds.

Princess Propane Range - 3-Burner from SEAWARD PRODUCTS
These Seaward ranges were rated #1 by Practical Sailor and Powerboat Reports. They feature stainless-steel construction and fuel lines, AGA approved thermocouple valves that shut off in case burners are extinguished, and piezo electric ignition that needs no electrical hookup. Safety clips secure range tops to eliminate rattling. Thermostatically-controlled 8000 Btu ceramic oven maintains steady temperature, distributes heat evenly, makes cleaning easy and conserves fuel. Built to ANSI Z. 21.

Crab Pot Puller from ENDURANCE MARINE
This powerful workhorse makes hauling prawn and crab pots quick and easy. Designed for high-speed retrieval with a robust 1. The heavy-gauge, marine-grade aluminum frame is powder coated for corrosion-resistance and can handle loads up to 150lb. The included foot control switch provides safety, ease of use and allows both hands free to bail line. Engineered to mount on the Scotty downrigger mount #1023, Model 435050, found on page 922. Stainless-steel internal shafts, fasteners and hardware.

"Little" Crane, 175 lb. Capacity, 30" Arm Reach, 7:1 Purchase, 75' Line Length from ST. CROIX MARINE
Precision engineered and fabricated from stainless steel, these removable cranes lift heavy loads with ease. Best of all, it takes just 20 seconds to set up or remove for storage. Optional spare mounting kits (VPN #176 & 196) include a set of brackets and rail clamps for an extra mounting location. Material: Polished stainless steel. Height: 60" mast height. Mounting Style: Horizontal or vertical mounting to railing. Included Equipment: Complete kit with mounts and 5/16" line.

Water Circulating Pump - #18-3581 - Chrysler Inbd # 3004886, 3619542, 3619859, 3745985 from SIERRA
Water Pumps The water pump is the heart of your inboard or I/O cooling system. All Sierra pumps are bidirectional and can be installed on reverse rotation engines. The pumps are also powder coated for additional protection. Includes mounting gasket. Pumps include brass bi-directional impellers, brass plugs and fittings, carbon resin seal, all mounting gaskets, stainless steel seal cup and spring, stainless steel back plate (where required), and powder coating for maximum corrosion protection.

Light Knives Illuminated Rigging Knife from MYERCHIN INC.
carry a Light Knife! It's dark, your hands are full and there's no way to hold a flashlight. The light is bright enough to let you read a chart 30 inches away, but because it's red it interferes less with your natural night vision. Stainless steel blade edge is 30% straight, 70% serrated for cutting nylon/polypro or tougher high-tech synthetic lines. Grip is ultralight Zytel® nylon. Secures to your belt or lifejacket with included clip. Serrated edge makes quick work of the toughest lines .