Top Sellers
CARB GASKET KIT from SIERRA
Sierra carb kits and gaskets for engine tune ups.
|
Yamaha Carb Kit from SIERRA
Sierra carb kits and gaskets for engine tune ups.
|
Replaces OMC P/N 378444 from SIERRA
Many of Sierra's solenoids are manufactured by our Independence, KS plant. We produce both starter solenoids and continuous duty solenoids for trim and tilt pumps. Our features add up to solenoids which offer maximum magnetic plunger pull, reduced voltage drop and maximum corrosion protection.
|
Impeller, 18-3062 from SIERRA
Recommended replacement schedule is every 3 years for fresh water and every year for salt water Click to view a Sierra Impeller Application Chart (PDF) For further assistance, have your year & model information handy and call our Product Advisors at 1-800-BOATING.
|
For Chrysler/Force, 89-817109A2 from SIERRA
Many of Sierra's solenoids are manufactured by our Independence, KS plant. We produce both starter solenoids and continuous duty solenoids for trim and tilt pumps. Our features add up to solenoids which offer maximum magnetic plunger pull, reduced voltage drop and maximum corrosion protection.
|
Water Circulating Pump - #18-3581 - Chrysler Inbd # 3004886, 3619542, 3619859, 3745985 from SIERRA
Water Pumps The water pump is the heart of your inboard or I/O cooling system. All Sierra pumps are bidirectional and can be installed on reverse rotation engines. The pumps are also powder coated for additional protection. Includes mounting gasket. Pumps include brass bi-directional impellers, brass plugs and fittings, carbon resin seal, all mounting gaskets, stainless steel seal cup and spring, stainless steel back plate (where required), and powder coating for maximum corrosion protection.
|
10 Micron Replacement Filter Element for OMC 502905 from SIERRA
High-performance fuel injected engines require ultimate fuel filtration, separation of water from the fuel supply and maximum fuel flow. Sierra’s new filter elements deliver all three of these critical performance factors. 7900-Series 10 micron filters eliminate harmful contaminants at over 90% efficiency, while removing over 99% of emulsified water. Today’s ethanol-blended fuels increase the chances of water in fuel tanks, resulting in premature wear, poor performance and component damage.
|
10 Micron Replacement Filter Element for Mercury 35-807172/35/35-802893Q, Yamaha ABB-FUELF-IL-TR (Short) from SIERRA
High-performance fuel injected engines require ultimate fuel filtration, separation of water from the fuel supply and maximum fuel flow. Sierra’s new filter elements deliver all three of these critical performance factors. 7900-Series 10 micron filters eliminate harmful contaminants at over 90% efficiency, while removing over 99% of emulsified water. Today’s ethanol-blended fuels increase the chances of water in fuel tanks, resulting in premature wear, poor performance and component damage.
|
Johnson/Evinrude Outboard Starter, 120 to 140hp V4 (1985-99), 10 tooth drive gear from SIERRA
Sierra's new and remanufactured starters are the only marine starters that meet Marine UL standards. Sierra's remanufactured starters all have new solenoids, drives, bushings, brushes and springs. The bodies are powder coated for greater corrosion resistance. Sierra has entered an agreement with United Technologies to market their complete line of outboard starters and components. All are 100% load tested . Our remanufactured starters are covered by Sierra's customer satisfaction warranty .
|
Aqua View Element Only, Mercury Replacement Element, Replaces Racor S3213 from SIERRA
High-performance fuel injected engines require ultimate fuel filtration, separation of water from the fuel supply and maximum fuel flow. Sierra’s new filter elements deliver all three of these critical performance factors. 7900-Series 10 micron filters eliminate harmful contaminants at over 90% efficiency, while removing over 99% of emulsified water. Today’s ethanol-blended fuels increase the chances of water in fuel tanks, resulting in premature wear, poor performance and component damage.
|
30GPH Cartridge, Replaces Racor S3240 from SIERRA
High-performance fuel injected engines require ultimate fuel filtration, separation of water from the fuel supply and maximum fuel flow. Sierra’s filter elements deliver all three of these critical performance factors. 7900-Series 10 micron filters eliminate harmful contaminants at over 90% efficiency, while removing over 98. They’re engineered for today’s sterndrives and inboards, along with 2-cycle and 4-cycle outboards. That is why a high efficiency water separating filter is so important.
|
60GPH Cartridge, Replaces Racor S3227 from SIERRA
High-performance fuel injected engines require ultimate fuel filtration, separation of water from the fuel supply and maximum fuel flow. Sierra’s filter elements deliver all three of these critical performance factors. 7900-Series 10 micron filters eliminate harmful contaminants at over 90% efficiency, while removing over 98. They’re engineered for today’s sterndrives and inboards, along with 2-cycle and 4-cycle outboards. That is why a high efficiency water separating filter is so important.
|
Upper Unit Seal Kit - OMC Sterndrive/Cobra from SIERRA
For 100-245 Stringer Unit (1968-72) Replaces 981799 Contains: One (1) Upper Gearcase Gasket (18-0939) - OE #315189. Four (4) Oil Seals (18-2073) - OE #981268. One (1) Rubber Seal (18-3111) - OE #907774. Two (2) Washers (18-4248) - OE #311598. Four (4) O-Rings (18-7103) - OE #308624. One (1) O-ring (18-7107) - OE #313175. One (1) O-Ring (18-7121) - OE #308621. One (1) O-Ring (18-7134) - OE #303059. One (1) O-Ring (18-7146) - OE #554545. Two (2) O-Rings (18-7198) - OE #308626.
|
|
|
Sierra-Tube-Exhaust from SIERRA
Some larger V-8 engines that create a large amount of back pressure use exhaust tubes rather than bellows. This helps to relieve the excessive pressure and eliminate problems with premature bellows failure. In the past, the exhaust bellows would blow up like a balloon and cause the drive shaft bellows to rub against the yoke and U-joints causing holes in the bellows.
|
|
Bearing from SIERRA, Gasket from SIERRA, Ballbearng from SIERRA
|
|
Home -> Engine Systems -> Engine Parts -> Tune Up Parts
**GasketSet-Short Block|**GasketSet-Short Block.
Part No: 18-1271
|
|
|
|
Home -> Engine Systems -> Engine Parts
**GasketSet-Short Block|**GasketSet-Short Block.
Part No: 18-1272
|
|
|
|
Home -> Engine Systems -> Engine Parts
**GasketSet-Head|**GasketSet-Head.
Part No: 18-1273
|
|
|
|
Home -> Engine Systems -> Engine Parts
For most popular marine versions of: Chevrolet In-line 4 & 6 cylinder V6 & V8 Engines and Ford 5. Minimizes inventory investment to cover most major engine applications. Maximizes inventory utilizations via mix and match system. Utilizes generic type gasket kits common among all engine brands. e. 7L) Crusader & Mercruiser would use the same short block & valve grind gasket sets, but would use different exhaust manifold gasket kits). Set 18-1274 contains: 18-2946 - Head Gasket.
Part No: 18-1274
|
|
|
|
Home -> Engine Systems -> Engine Parts
**GasketSet-Head|**GasketSet-Head.
Part No: 18-1275
|
|
|
|
Home -> Engine Systems -> Engine Parts
**GasketSet-Short|**GasketSet-Short.
Part No: 18-1276
|
|
|
|
Home -> Engine Systems -> Engine Parts
For: 4 cyl. 3. 7L Mercruiser 470 Kit contains: 18-0158 - Intake Gasket. 18-2848 - Quadrajet Gasket. NSS - Valve Grind Cover Gasket. 18-3878 - Head Gasket. 18-0992 - Exhaust Manifold Mounting Gasket.
Part No: 18-1277
|
|
|
|
Home -> Engine Systems -> Engine Parts
**GasketSet-Head|**GasketSet-Head.
Part No: 18-1278
|
|
|
|
Home -> Engine Systems -> Engine Parts
**Screw with O-Ring|**Screw with O-Ring.
Part No: 18-1280
|
|
|
|
Home -> Engine Systems -> Engine Parts
For use with ignition kill switch .
Part No: 18-1282
|
|
|
|
Home -> Engine Systems -> Engine Parts->Sierra Gaskets
Sierra gaskets for a variety of purposes Choose by Sierra part numbers.
Part No: 18-1283
|
|
|
|
Home -> Engine Systems -> Engine Parts->Sierra Gaskets
Sierra gaskets for a variety of purposes Choose by Sierra part numbers.
Part No: 18-1284
|
|
|
|
Home -> Engine Systems -> Engine Parts->Sierra Gaskets
Sierra gaskets for a variety of purposes Choose by Sierra part numbers.
Part No: 18-1285
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Foward Gear and Bushing|**Foward Gear and Bushing.
Part No: 18-1287
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Pinion Gear|**Pinion Gear.
Part No: 18-1288
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Gear Set|**Gear Set.
Part No: 18-1291
|
|
|
|
Home -> Engine Systems -> Engine Parts
**Bearing-Rod|**Bearing-Rod.
Part No: 18-1333
|
|
|
|
Home -> Engine Systems -> Engine Parts -> Tune Up Parts
**Bearing-Rod|**Bearing-Rod.
Part No: 18-1334
|
|
|
|
Home -> Engine Systems -> Engine Parts -> Tune Up Parts
**Bearing-Rod|**Bearing-Rod.
Part No: 18-1337
|
|
|
|
Home -> Engine Systems -> Engine Parts -> Tune Up Parts
**Cam Bearings|**Cam Bearings.
Part No: 18-1339
|
|
|
|
Home -> Engine Systems -> Engine Parts
**Bearing-Rod|**Bearing-Rod.
Part No: 18-1341
|
|
|
|
Home -> Engine Systems -> Engine Parts
**Bearing-Rod|**Bearing-Rod.
Part No: 18-1342
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Retaining Tab|**Retaining Tab.
Part No: 18-1343
|
|
|
|
Home -> Engine Systems -> Engine Parts
**Bearing|**Bearing.
Part No: 18-1344
|
|
|
|
Home -> Engine Systems -> Engine Parts
**Ball Bearing|**Ball Bearing.
Part No: 18-1345
|
|
|
|
Home -> Engine Systems -> Engine Parts -> Tune Up Parts
**Ball Bearing|**Ball Bearing.
Part No: 18-1346
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Bearing-Carrier|**Bearing-Carrier.
Part No: 18-1350
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Bearing-Carrier|**Bearing-Carrier.
Part No: 18-1351
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Bearing-Center Main|**Bearing-Center Main.
Part No: 18-1352
|
|
|
|
Home -> Engine Systems -> Propellers & Drive Trains
**Bearing-Center Main|**Bearing-Center Main.
Part No: 18-1353
|
|
|