T-Top Boat Cover, Center-Line Length 20'5" to 21'4", Blue from TAYLOR
The main features of these covers are: Bow and stern sections are separated into two halves. The sections are joined through the use of a 7mm single pull molded nylon zipper on both the port and starboard sides. Cover design incorporates a "console tube" section with two adjustable straps which lift and secure the cover halves up and over the console body and up under the T-top. The top edge of console tube incorporates an adjustable draw rope in both front and rear sections.

T-Top Boat Cover, Center-Line Length 19'5" to 20'4", Blue from TAYLOR
The main features of these covers are: Bow and stern sections are separated into two halves. The sections are joined through the use of a 7mm single pull molded nylon zipper on both the port and starboard sides. Cover design incorporates a "console tube" section with two adjustable straps which lift and secure the cover halves up and over the console body and up under the T-top. The top edge of console tube incorporates an adjustable draw rope in both front and rear sections.

ADJ 7-15-DL Whisker Pole, 83"/9lb. Collapsed Length/Weight, 202" Max. Working Length, 2" Tubing Diameters from FORESPAR
These telescoping whisker poles are heavy-duty two-section and three-section aluminum spars which can be extended to lengths up to 17' and securely locked in position by an internal twist lock device. Poles feature self-latching Ultra Series™ fittings on the inboard and outboard ends. Aluminum tubing. End Fitting Inboard: UPX. End Fitting Outboard: UPX.

Furler Kit for Boat Length to 16', 500lb. SWL, 1/8" Max. Wire dia., 1/4" Pin dia., 2-1/2" Pin-to-Pin, 5/32" Furling Line dia. from HARKEN
Furl or set your jib from your cockpit Harken small boat furlers allow the sail to be set and furled from the cockpit, a critical convenience in many racing dinghies and trailerable sailboats. Constructed of Hardkote anodized Teflon-impregnated aluminum, they feature multiple stacked races of Delrin or Torlon ball bearings for smooth rotation under load. The jib’s luff wire must be properly seized to the sail, since it carries most of the headstay load. 434 furler for dinghies under 16ft. (4.

Gunnel Guard - 1/2" Round, 1-1/2" Diameter, 20' Length from TAYLOR
These polyester-covered guards will protect your boat from dings and scratches and they won’t rot in the sun or saltwater like cotton guards. Great for use on dinghies and swim platforms, too. Fabric tabs attach easily with screws or nails. Half Round is for flat surfaces; 3/4 Round is for 90° edges. Sold in 10' or 20' lengths or by the foot up to 50'. Material: Polyester fabric/closed-cell foam . Attachment Method: Screws or nails . Shock Absorption Mechanism: Foam padding .

Ultra Blue Three-Strand Line, 1/4" Dia., 1,700lb. Breaking Strength from SAMSON ROPE
Ultra-strong line outlasts polypro two to one Made from bi-polymer olefin fiber, ultra-strong Ultra Blue is 30%–35% stronger than polypropylene and has more than twice the wear life. UV light resistance is excellent, it is easy to grip and it floats.

3/16" AmSteel-Blue Rope, Red from SAMSON ROPE
AmSteel-Blue is a 12-strand braided rope utilizing Parallay design with our proprietary blue Samthane coating with Dyneema® SK-75 fiber. This rope yields the maximum in strength-to-weight ratio and is stronger than wire rope constructions—yet it floats. Superior flex, fatigue and wear resistance. Stronger than AmSteel. Much stronger than steel. Very low stretch. Easily spliced. Superior flex.

84”L Fiberglass Bow from TAYLOR
Bows moounted in bow sockets are the sure and easy way to keep a boat cover taut and free from water-collecting pockets. Sockets can be mounted on any rail system or anywhere on deck wall. Rubber gasket provides snug fit for fiberglass bows. Super strong and flexible, will not take a “set”. Cut to desired length. Incude rubber end covers to grab socket.

Flat Cam Riser, 1"H from HARKEN
Harken Cam-Matic cleats are legendary for smooth operation when holding and releasing control lines. Three rows of Delrin ball bearings allow the jaws to open and close smoothly under the highest loads. Light springs allow the cleats to open freely, so the teeth do not have to be sharp which means that your line lasts longer. Use models with aluminum jaws for high loads, or when the line will be drawn through the teeth for adjustment.

RigTune Pro Digital Rig Tension Gauge from HARKEN
Old-fashioned spring gauges, like the Loos Pro, don’t provide repeatable numbers. This product does. Unlike spring-loaded gauges, the Harken Rigtune Pro measures rig tension to the nearest kilogram. A load cell records the pressure on one of the pins and the measurement is displayed on a simple, easy-to-read screen. The Rigtune Pro fits a specific range of rigging sizes, 2. As rigging is deflected over three pins on the back of the gauge, a load cell records the pressure on one of the pins.

Hatch Riser Arm for 20" x 20" Hatch from TAYLOR
Replacement arms for Taylor hatches from 1987 to the present. Universal arms can be left or right.

Fishing Boat Cover - HS Blue 15'5"-16'4"/65" Beam from TAYLOR
Patterned to fit basic fishing boats with bench seats. (These covers are not patterned to fit over trolling motors. ) The bow and transom corners are reinforced to protect the cover from sharp aluminum edges. Poly Cotton Fabric: Trailerable 65% polyethelyne/35% cotton Breathable Mildew & Stain Resistant Water Repellant Heavy-gauge shock cord in hem 2-year limited warranty Color: Silver Gray. Hot Shot Fabric (HS): Trailerable 100% urethane-coated polyester 7.

10mm Ball Stud pair from TAYLOR
Taylor 10mm Ball Stud pair.

Replacement Ball Bearings for 150 Cam Cleat from HARKEN
Harken Cam-Matic cleats are legendary for smooth operation when holding and releasing control lines. Three rows of Delrin ball bearings allow the jaws to open and close smoothly under the highest loads. Light springs allow the cleats to open freely, so the teeth do not have to be sharp which means that your line lasts longer. Use models with aluminum jaws for high loads, or when the line will be drawn through the teeth for adjustment.

AC 36-Position Circuit Breaker Panel, 27 Circuit Breakers, 14-3/4" x 11-1/4" from BLUE SEA SYSTEMS
Blue Sea Systems designs innovative, reliable, superior quality electrical system products. Blue Sea Systems products are tested aboard the company's boat to ensure reliability and ease of use in real world conditions. This results in the delivery of innovative, reliable electrical products that exceed the quality standards of other companies. Blue Sea Systems' in-house lab is used to load test and thermal test products to ensure they will perform under marine conditions. Digital Multimeter.