Gen-Sep Water Separator, 2" Diameter, Gas In/Out 2.0", Water Outlet 1.5" from CENTEK INDUSTRIES
Position the water drain from the Gen-Sep just below the water line to eliminate water splash, especially important for nighttime operation. Gen-Sep will remove nearly all of the cooling water from the exhaust. That water can then be drained to a hull fitting just below the waterline, thus eliminating excess noise often created by splashing and pulsating water flow at the exhaust outlet. A slight downward angle is required for both the exhaust outlet and the exhaust gas tube. Dimensions: 10.

2" ID, 90° Marine Rubber Exhaust Elbow from SHIELDS RUBBER
Exhaust hose elbows let your wet-exhaust line make tight turns without kinking. They provide excellent tolerance to engine heat, vibration and back pressure. Install over rigid tubing or pipe using the four included stainless T-bolt clamps (two at each end). Not intended for hose-to-hose connections. Lubricate with water or detergent. 250°F max.

Fuel Filter Only from MERCURY MARINE
1662576 is a kit for gasoline outboard and MerCruiser models, except 1992 MCM 4. 3L Gen II engines equipped with an in-line fuel filter. 1662550 is an individual replacement element. Model 4531430 is located under the cowl on all Mercury/Mariner V6 outboards, up to 1995, and includes black screw-in sensor. Similar 5037320 is under-cowl filter for Mercury/Mariner V6, 1996 and up, with blue screw-in sensor. OMC model replaces OMC# 502905. Fuel Type: Gasoline. Filtering Efficiency: 25 micron .

Personal Watercraft 2-Cycle Full Synthetic Oil, Quart from MERCURY MARINE
Engineered for air or liquid-cooled watercraft engines or engines which specify the use of API-TC type oils including WaveRunner, Sea-Doo and Polaris watercraft.

Fuel Filter Primer Pump Kit from RACOR-PARKER FILTRAT
Prime your fuel line reliably every timeRetrofit this kit to most Racor 1000 or 900 series fuel filters, and you can easily reprime your filter and fuel system. Activate a switch, and fuel is drawn into the pre-screen and pumped through the housing, re-filling the unit. When not in use, the filter pump is bypassed and the fuel/water separator system functions normally. Assembly is only 3. 3" tall .

Fuel Sending Unit Only - 4-24'' Tank from TELEFLEX
Complete kit includes a reliable dash-mount gauge with a black face and white numerals. The triple patented sending unit has an adjustable float arm and U-channel that fits virtually all tanks from 4"-24" deep. Compatible with 12V DC systems with common or insulated ground.