Top Sellers
1-1/2" Traveler Track End Stop from SCHAEFER
Stop-End Traveler 1. 5in|Stop-End Traveler 1.
|
|
|
Hi-Load Ti-Lite Car, Torlon Bearings, 850lb. SWL from HARKEN
These lightweight, solid aluminum and compact captive ball (CB) travelers are built to handle very high loads. Captive ball bearings let you roll the cars on and off the track without using a ball loader. Boat Size: Dinghies, multihulls, to small offshore boats. Material: One-piece solid aluminum . Shackle: Pivoting toggle models—fasten control blocks directly to post without needing a shackle. Sheave: Fixed sheave models—mainsheet loads 40° or less from vertical.
|
Spinnaker Pole Car, Track #2720, 900sq.ft. Max. Sail Area, 1125lb. SWL from HARKEN
Now with captive ball bearings, which eliminates the need for a ball-bearing loader during installation or removal from track. These cars run freely, fit low-beam traveler track and are easy to adjust under any load.
|
Dacron Sail Repair Tape, 3" x 150' from BAINBRIDGE
Make emergency sail repairs with tough, sticky Dacron tape For temporary, emergency sail repairs. Much tougher, stronger, and stickier than spinnaker repair tape.
|
Dacron Sail Repair Tape, 3" x 15' from BAINBRIDGE
Make emergency sail repairs with tough, sticky Dacron tape For temporary, emergency sail repairs. Much tougher, stronger, and stickier than spinnaker repair tape.
|
|
Home -> Sailboat -> Traveler, Tracks & Vang -> T Track & Sail Track
|
|
Home -> Sailboat -> Traveler, Tracks & Vang -> T Track & Sail Track
Superior dry lubrication for moving or stationary parts. Displaces moisture and inhibits corrosion. Fortified with PTFE to provide a micro-thin film that won’t attract dust or dirt. Dries in seconds. Will not stain sails or clothes. Great for mast track, genoa or traveler T-track, headsail grooves, hinges, zippers, headfoils, and sliders.
Part No: 06114
|
|
|
|
Home -> Sailboat -> Traveler, Tracks & Vang -> T Track & Sail Track
Track and Car 6061-T6 Hardkote Anodized, Teflon impregnated aluminum.
Part No: 453.24
|
|
|
|
Home -> Sailboat -> Traveler, Tracks & Vang -> T Track & Sail Track
End Stop 32mm T-Track.
Part No: B810
|
|
|
|
Home -> Sailboat -> Traveler, Tracks & Vang -> T Track & Sail Track
Some beam tracks can only use metric fasteners; see table for details. The moment of inertia is used to calculate the stiffness of material section. Beam track is available from size 0 to 3 and is used when spanning cockpits and across companion way hatches. Three fixing bolts should always be used either side of the span and washers fitted under the head of the bolt and between track and deck. Weight (per meter): 128. Max span between Fixings: 35". Moment of inertia (mm4): 343124.
Part No: 29163330
|
|
|
|
Home -> Sailboat -> Traveler, Tracks & Vang -> T Track & Sail Track
Fits Ronstan Series 19 I-Beam & Series 25 T-Track Made from impact-resistant, U. V.
Part No: RC7250-INS
|
|
|
|
Home -> Sailboat -> Traveler, Tracks & Vang -> T Track & Sail Track
Hullkote applies in half the time that standard petroleum-based polishes do—just wipe on and wipe off—no waiting for anything to dry, no crusty haze to remove and no heavy buffing is required. You’ll only need to use about half as much product as you normally would and it lasts more than 20 days with two coats. Offers superior UV protection and adheres right over the top of other polishes. Tested and proven in a variety of competitive classes.
Part No: 7880
|
|
|
