Series 250 Exhaust Hose, 2-3/8"ID, 2-3/4"OD, 230psi Burst Pressure from SHIELDS RUBBER
For use in all marine water and wet-exhaust applications. Also for marine wet-exhaust where connection requires great length (greater than 4 x ID) or significant bend. Meets or exceeds standards for certified wet-exhaust hose. Sold by the foot with a maximum continuous length of 10' except where preceded by an asterisk, which indicates a maximum continuous length of 50'. Construction: Black synthetic rubber with wire helix and HD synthetic cord . Temperature Range: –20° to 200° F .

Series 250 Exhaust Hose, 7/8"ID, 1-3/16"OD, 565psi Burst Pressure from SHIELDS RUBBER
For use in all marine water and wet-exhaust applications. Also for marine wet-exhaust where connection requires great length (greater than 4 x ID) or significant bend. Meets or exceeds standards for certified wet-exhaust hose. Sold by the foot with a maximum continuous length of 10' except where preceded by an asterisk, which indicates a maximum continuous length of 50'. Construction: Black synthetic rubber with wire helix and HD synthetic cord . Temperature Range: –20° to 200° F .

Dyform Wire - 6MM 1X19, 7810BL from NAVTEC
Control your rig and sail plan more accurately with a low-stretch, high-performance wire strand. Dyform is an essential performance requirement on many racing sailboats and on cruising yachts seeking higher performance and greater margins of safety. It has 30% greater breaking strength and 25% less stretch than conventional wire strand. Wire strands are specially shaped to fill more cross sectional area for greater resistance to elastic stretch. Same corrosion resistance of 316S31 stainless.

Gusher MKIII Cabinet-Mount Foot Pump, Right-Handed from WHALE PUMPS
This surface-mounted pump can be placed inside or outside a locker. Discharges on each stroke and self-primes (to 7' max. height). Offered in “Right” and “Left” configurations to suit installation clearance requirements. For freshwater or saltwater. gpm: 4. 3 . Dimensions: 5-1/8"H x 5"W x 3-5/8"L (excludes 4-1/8" foot pedal) .

Wiretec 405 Sparkplug Wire Set from WIRE TEC (MAGSTAR)
WIRETEC 405 SPARKPLUG WIRE.

Hot Foot Throttle Omc/Merc from T-H MARINE
Replaces your hand throttle with a foot pedal that makes you feel like you're behind the wheel of your automobile. When released, the Hot Foot automatically returns your engine to the idle position thanks to a strong stainless spring. Mounts directly to the deck of the boat and uses standard control cables. Aluminum pedal. Stainless hardware. Non-stick bearing surfaces.

Halyard Kit, 1/8" Wire Dia., 3/8" Line Dia., 40' Wire Length, 40' Line Length from WEST MARINE RIGGING
Convenient, do-it-yourself kits offer an economical way to replace old halyards We offer these kits for those who want to replace their old halyards or install new low-stretch halyards. Made of the highest quality 7x19 oil-free stainless wire and New England Ropes premium white Sta-Set yacht braid. Comes with a Flemish eye at the rope end, and a thimble and sleeve, but no shackle. Rope Type: Sta-Set Yacht Braid . Shackle: Flemish eye splice, sleeve and thimble, no shackle .

Braided Polyester Cord, by the Foot from NEW ENGLAND ROPES
A low-stretch cord that’s great for flag halyards, foredeck netting, or light-air spinnaker sheets. Sold by the foot. Diameter: 1/8". Best use: Utility cord, flag halyards . Construction: Braided polyester . Breaking strength: 530lb. . Stretch: 3% at 15% of breaking strength .

Bluefever Wire Max Glove, L from AFTCO
Bluefever Wire Max Glove L|Bluefever Wire Max Glove L.

5/16" Wire Rope Clamp from SEADOG
Investment Cast 316 Stainless Body / AISI 304 Stainless U-Bolt. Accepts 5/16" wire. 1-5/8" Long. 1-3/8" wide.

Furler Kit for Boat Length to 16', 500lb. SWL, 1/8" Max. Wire dia., 1/4" Pin dia., 2-1/2" Pin-to-Pin, 5/32" Furling Line dia. from HARKEN
Furl or set your jib from your cockpit Harken small boat furlers allow the sail to be set and furled from the cockpit, a critical convenience in many racing dinghies and trailerable sailboats. Constructed of Hardkote anodized Teflon-impregnated aluminum, they feature multiple stacked races of Delrin or Torlon ball bearings for smooth rotation under load. The jib’s luff wire must be properly seized to the sail, since it carries most of the headstay load. 434 furler for dinghies under 16ft. (4.

1/8" Single Braid, 2300lb. Breaking Strength, Green from SAMSON ROPE
The high-strength, low-stretch equivalent to wire rope with seven times less weight! Combined with flex-fatigue and service life durability, Amsteel 12-strand Dyneema SK-75 single braid can outlast wire rope and has none of the handling and safety issues associated with wire. Stretch: 0. 70% at 20% of breaking strength. Best Use: Cascade systems, replacements for wire halyards, tapered sheets, backstays, runners, checkstays and strong ultralight rigging . Construction: 12-strand single braid .

3/16" AmSteel-Blue Rope, Red from SAMSON ROPE
AmSteel-Blue is a 12-strand braided rope utilizing Parallay design with our proprietary blue Samthane coating with Dyneema® SK-75 fiber. This rope yields the maximum in strength-to-weight ratio and is stronger than wire rope constructions—yet it floats. Superior flex, fatigue and wear resistance. Stronger than AmSteel. Much stronger than steel. Very low stretch. Easily spliced. Superior flex.

Light for Windex 10, 15 & Sport Wind Indicators from DAVIS INSTRUMENTS
This masthead light illuminates Windex® wind indicators for perfect night sailing Illuminates reflective reference tabs on underside of the Windex 10 and 15. Mounts directly to the masthead fitting. Draws only 120mA . Mast wire not included . Made of non-corrosive materials . Replacement bulb for Model 4481503.

Straight Adapter, 30A Male/15A Female (straight blade, not locking, connections) from MARINCO
Marinco straight adapters allow you to connect from one dockside receptacle (or other power source receptacle) to one boatside inlet or equipment of dissimilar power configuration. They are integral fittings with no wire between the end fittings. They are high-quality, but do not have sealing boots and are not recommended for use in wet applications.