Skip to content Skip to navigation menu
FPM-050 Fuel Polishing Module Clearance

FPM-050 Fuel Polishing Module

Model # 10954717 | Mfg # FPM-050

This item is no longer available.

Condensed water in a diesel fuel system can lead to fuel degradation and costly maintenance problems. The FPM-50 installs in-line between your existing fuel filter and the engine. To prevent the accumulation of water and contaminants, the FPM-50 circulates fuel at a low-flow rate which enables the filter to separate out difficult-to-remove emulsified water that can only be removed at low flow rates. Low-flow polishing with the FPM-50 removes moisture that high flow polishing systems can leave behind. In addition to preventing contaminant build-up, the need for expensive fuel treatments and additives is reduced. With the FPM-50, you can polish your fuel non-stop, even during periods of engine down time and winter storage. The system is easy to install and operate and it incorporates an automatic, full-flow bypass valve which eliminates the need for manual switching. With a draw of just 150mA, battery drain is minimized. In fact, the FPM-50 can be run off a small solar panel.

Filtration Rate: Typical rate is 50gal./day; Actual rate is system dependent
Voltage Requirements: 10-16V DC; 12V DC nominal
Dimensions: 3.87" L x 2.47" W x 2.14" D (3.8 7" L x 4.48" W x 2.14" D including bracket)
Port Sizes: Inlet and outlet: 3/8" NPTF; Recirculation port: 1/4" NPTF
Draw: Less than 2W (Less than 3 Ah/day)
Weight: Less than 2lb.
Acceptable Fuels: Diesel, Bio-diesel, kerosene
Warranty: One year

West Advisor

The West Advisor articles have answered boaters' questions and provided solutions to boating problems for more than 20 years. West Marine has compiled one of the Web's most comprehensive collections of technical boating information articles.