SeaStar® P/APower Assist Steering, Type 1 12V Autopilot Pump
Converts manual hydraulic steering for dramatic reduction in steering wheel torque and at the same time provides a pump for an autopilot installation.
The SeaStar Power Assist Autopilot pump is the standard power assist product with the addition of a Type 1 autopilot pump. The SeaStar Autopilot pump is a fixed flow, reversible pump set that uses an internal hydraulic gear pump, producing very little vibration or noise.
- Autopilot ready – a single installation (i.e. no need to break into system for install of pump)
- Converts manual hydraulic steering to power steering
- Dramatic reduction in steering wheel torque
- Easy installation
- OEM or Retrofit
- Simple add on to an existing SeaStar manual system (from 1.4 – 2.4 SeaStar helm pumps)
- Compatible with power purge system
- Ignition protected (SAE J-1171)
- ABYC, CE, NMMA, ISO 10592 Approved
- Replaces other 12 & 24 volt systems
Wire Details
Length: 24"
Gauge: #12 AWG
Connector: None - Bare Leads
Oil Compatibility: SeaStar Steering Fluid (MIL 5606)
Weight: 4.9 lb.
Autopilot Pump Sizes
Type 1: 60 cu. in./min (no-load)
Maximum Pressure: 1000 psi
Typical Current Draw 12V Type 1: 4 – 8 amps (Depending on Application)
Autopilot Pump Cylinder Capacity
Type 1 4.9-12.5 cu. in.
