Unepoxy Plus Bottom Paint, Gallon
Frequently Bought Together
Unepoxy Plus is a modified epoxy bottom paint that dries to a hard, abrasion resistant finish.
Resistant to algae, barnacles, grass, zebra mussels and other fouling, Unepoxy Plus is a good choice for boaters who wish a single-season, hard antifouling paint at a moderate price. Recommended for low to moderate fouling waters, Unepoxy Plus can be applied to fiberglass, wood and properly primed steel hulls. Do not apply to aluminum hulls. Offered in Red, Blue, Black and Green.
Key Features
- Hard, smooth finish
- High Copper content fights marine growth
- Apply over most other antifouling
- Withstands trailering, beaching, and season-long use
Physical Data
- Type: Modified Epoxy/Rosin
- Finish: Flat
- Available colors: Red, Blue, Black, Green
- Components: 1
- Curing mechanism: Solvent Release
- Solids by weight: (Theoretical): 74 +/- 2%
- Solids by Volume: (Theoretical): 45 +/- 2%
- Coverage: 400sq.ft./gal.
- VOC: 490 g/l max.
- Active ingredients: 45.7% Cuprous oxide
- Flash point: 116°F (SETA)
Application
- Application Method: Brush, roller, airless, or conventional spray
- Number of coats recommended: 2
- Dry Film Thickness: 2 mils
- Wet Film Thickness: 4.8 mils
- Applicator: High-quality short nap roller (maximum 3/8” nap)
- Application temperature: Min. /Max. Range: 40° F. Min/90°F. Max
- Thinner: Special Thinner 120 model 249961; Spray: 121 Spraying Thinner, model 249995
Drying times (Hours)
Drying | @40°F | @70°F | @90°F |
---|---|---|---|
To recoat | 12 hr. | 6 hr. | 3 hr. |
To launch | 24 hr. | 16 hr. | 8 hr. |
*The above dry times are minimums. May be recoated after the minimum time shown. There is no maximum dry time before launching.
Get the right amount of paint:
Boat Type | Bottom Paint |
---|---|
10' Dinghy | 1 qt. |
14' Outboard | 1-2 qt. |
18' Runabout | 2 qt. |
20' Sailboat | 3 qt. |
24' Runabout | 3-4 qt. |
30' Sailboat | 1.5 gal. |
32' Cruiser | 1.5-2 gal. |
36' Auxiliary | 2 gal. |
40' Cruiser | 2.5 gal. |
45' Sailboat | 3-3.5 gal |
50' Sportfisher | 4+ gal. |
Another way to determine bottom paint quantity is to estimate the approximate surface area of the hull below the waterline, using the following formula:
Length x Beam x .75 = Approximate underwater surface area in square feet.
Each paint has a “theoretical coverage” area, but most paints require at least two coats, so you can expect actual coverage to be no greater than half of the theoretical value.
More Information
For detailed application instructions and to view available colors, see the Unepoxy data sheet.
NOTE: Manufacturer data sheets are subject to revision. Linked data sheets are believed to be accurate at the time of publication.