Micron Optima
Water-based antifoling with biolux technology resulting in a smooth finish
Interlux Micron Optima Antifouling—Powerful Water-based Micron Technology providing excellent multi-seasonal performance in the most challenging conditions. Micron Optima uses Activated Biolux Technology to block slime and algae. Micron Optima is low V.O.C. and low odor and being water based, clean-up is easy. It can be applied over other water-based products and other Microns. Use Micron Optima on power and sailboats in all waters.
Key Features
- Water-based Micron technology
- Activated Biolux technology
- Suitable for all power and sail
- Reduced drag, No Build-Up
- Multi-seasonal performance
Physical Data
- Type: Dual-Biocide water based ablative
- Finish: Matte
- Available colors: Blue, Green, Red, Black,
- Components: 1
- Curing mechanism: Solvent Release
- Solids by Volume: 61%
- Coverage: 496.7sq. ft./gal.
- VOC: 240 grams/liter (Max)
- Active ingredients: 37.2% Cuprous Oxide
- Flash point: 98°F Degree
Application
- Application Method: Brush, roller, airless, or conventional spray
- Number of coats recommended: 2-3 minimum Bare Wood: 3 coats (first thinned)
- Wet Film Thickness: 3.3 mils
- Dry Film Thickness: 2 mils
- Applicator: High-quality short nap roller (maximum 3/8” nap) brush
- Application temperature Min. /Max. Range: 10°C/50°F and maximum 35°C/95°F.
- Thinner: Water, do not thin more than 10% by volume
Drying Times* (Hours)
| Drying | @41°F | @59°F | @73°F | @95°F |
|---|---|---|---|---|
| To touch | ------- | 3 hr. | 2 hr. | 1 hr. |
| To recoat | 7 hr. | 5 hr. | 4 hr. | 3 hr. |
| To launch | 72 hr. | 24 hr. | 7 hr. | 5 hr. |
*The above dry times are minimums. May be recorded after the minimum time shown. There is no maximum dry time before launching.
Get the right amount of paint:
| Boat Type | Bottom Paint |
|---|---|
| 10' Dinghy | 1 qt. |
| 14' Outboard | 1-2 qt. |
| 18' Runabout | 2 qt. |
| 20' Sailboat | 3 qt. |
| 24' Runabout | 3-4 qt. |
| 30' Sailboat | 1.5 gal. |
| 32' Cruiser | 1.5-2 gal. |
| 36' Auxiliary | 2 gal. |
| 40' Cruiser | 2.5 gal. |
| 45' Sailboat | 3-3.5 gal |
| 50' Sportfisher | 4+ gal. |
Another way to determine bottom paint quantity is to estimate the approximate surface area of the hull below the waterline, using the following formula:
Length x Beam x .75 = Approximate underwater surface area in square feet.
Each paint has a “theoretical coverage” area, but most paints require at least two coats, so you can expect actual coverage to be no greater than half of the theoretical value.
More information
For detailed application instructions see the Micron Optima Data Sheet.
NOTE: Manufacturer data sheets are subject to revision. Linked data sheets are believed to be accurate at the time of publication.
