Tuff Stuff Primer Kit
Complete Your Purchase
Using Tuff Stuff, you can create a barrier coat in as little as two days!
More than a simple primer, Tuff Stuff is a multi-purpose, high-build, two-part epoxy that, in addition to use as a universal metal primer, can be used to repair fiberglass blisters and create a bottom paint-ready barrier coat in as little as two days. Using microsheet silicate technology, Tuff Stuff seals out water with millions of overlapping microscopic sheets that provide an impermeable barrier against water penetration.
In addition to blister prevention on fiberglass, Tuff Stuff can also be used as a bilge coating due to its resistance to oil and water. As a universal primer, it can be used for corrosion protection on most metals below the waterline and for priming any metal. Tuff Stuff creates an overlapping barrier to eliminate any direct path for water migration. Tuff Stuff can be used on aluminum, bronze, stainless steel, cast iron, and lead, both above and below the waterline, making it an excellent choice for priming props, shafts, keels, trim tabs, through-hulls, and lower units. Not for sale in States where prohibited by law.
Key Features
- Creates an impermeable barrier against water intrusion
- Excellent chemical and solvent resistance
- Good choice for coating bilges
- High-build formula means fewer coats needed
- A longer window between coats makes application easier
- Fast-drying formula reduces labor and yard time
Physical Data:
- Type: Two-part epoxy
- Finish: Matte
- Available Colors: Gray, White
- Components: 2
- Mix Ratio: 1:1
- Induction time: 20-30 min.
- Solids by Volume: 52% +/- 2%
- Theoretical Coverage: 140 sq. ft/gal. @ 6mil. DFT
- VOC: 444g/l
- Flash Point: 80°F
Application
- Application Method: Brush, roller, airless, or conventional spray
- Number of Coats Recommended: 2 minimu,m depending on intended service
- Wet Film Thickness/coat: 11.5-14.5mil.
- Dry Film Thickness/coat: 6-7.5mil.
Drying Times*
| Drying | 73°F |
|---|---|
| To touch | 2 hr. |
| To recoat with Tuff Stuff (min.) | 3 hr. |
| To recoat with Tuff Stuff (max.) | 6 days |
| Overcoat with bottom paint (max.) | 12 hr. |
More information
For detailed application instructions, see the Tuff Stuff Data Sheet. NOTE: Manufacturer data sheets are subject to revision. Linked data sheets are believed to be accurate at the time of publication.
You May Also Like
