Raises and lowers outboards with the touch of a switch to achieve better performance. It has 20° of trim and a total of 90° of trim and tilt. Pop up on a plane faster, and achieve better performance underway as load and water conditions change. You get a more stable ride, increased top end speed, and better fuel efficiency. The 6" setback enhances boat stability because the increased clearance enables the prop to get a better “bite” at higher prop settings.
Durable 6061 T6 aluminum throughout, a self-contained hydraulic power unit, and 2" dia. hydraulic cylinder rated at 7,800lb. of thrust. Completely sealed and submersible. Rated for 10hp-130hp engines, and pre drilled to fit standard B.I.A. hole. Comes with or without a dash-mount position indicator, and includes all mounting hardware. 16 3/8"W x 14"H.
|Capacity||10 HP to 130 HP|
|Type||Power Trim & Tilts|
Reviewed by 1 customer
Displaying review 1
Comments about Cmc Marine Power Tilt/Trim without Gauge:
Bought this unit for an older Evinrude 55hp when the factory trim wore out and unable to find replacement. Unit is everything I expected it to be and more. Extremely well build and solid made of high quality materials. Performs well as both trim unit and setback plate. Only fault is that it is not possible for the wiring harness to meet the lengths needed by everyone. They terminate every wire, switch wires, battery leads and trim unit wires. I had to shorten the switch wires and lengthen the negative battery lead and the trim unit wires. Might be better for them to supply the harness with longer lengths on all wires and let the customer cut and terminate for themselves. But this really is a small issue and the product quality and performance is great.